Page 1 of 1
FOUND: Tonearm Part For VV-IV
Posted: Tue Apr 25, 2017 2:20 pm
by OrthoSean
Folks,
I picked up a VV-IV the other day and it's missing the small piece on the top of the tonearm where the pivot pin locks in. I've attached a photo that hopefully shows what's missing. Can anyone help?
Thanks!
Sean
Re: WANTED: Tonearm Part For VV-IV
Posted: Tue Apr 25, 2017 6:24 pm
by EdiBrunsVic
Perhaps Ron Sitko has the part you need.
Re: WANTED: Tonearm Part For VV-IV
Posted: Wed Apr 26, 2017 7:43 am
by OrthoSean
I don't think Ron has these.
Sean
Re: WANTED: Tonearm Part For VV-IV
Posted: Thu Apr 27, 2017 5:12 pm
by OrthoSean
Bump
Re: WANTED: Tonearm Part For VV-IV
Posted: Wed May 03, 2017 9:15 am
by OrthoSean
One last bump. I'd even take the whole tonearm if anyone has one...
Sean
Re: WANTED: Tonearm Part For VV-IV
Posted: Wed May 03, 2017 9:54 am
by briankeith
George V. maybe?
Re: WANTED: Tonearm Part For VV-IV
Posted: Wed May 03, 2017 9:59 am
by OrthoSean
George does not have the part, he has the whole tonearm.
I'd still rather give TMF people the opportunity to take my money first. George will be my next step if I have to.
Sean
Re: WANTED: Tonearm Part For VV-IV
Posted: Wed May 10, 2017 6:20 pm
by VictrolaGuy - Walt
OrthoSean wrote:One last bump. I'd even take the whole tonearm if anyone has one...
Sean
Sean,
Do you still need the solid pivot block for the VV-IV taper tube? Just say the word and I will send it to you.
I saw your post over a week ago but didn't have a chance to dig around in the deeper darker places of my shop until this morning.
Walt
Re: WANTED: Tonearm Part For VV-IV
Posted: Thu May 11, 2017 8:02 am
by OrthoSean
I ended up getting one from George V. Had to buy the entire tonearm because he wouldn't part one out, so I'm now just waiting for it to arrive, but thank you for the offer!
Sean