Page 1 of 1
WANTED: Lower Belt Pulley For A Col AT
Posted: Fri Jun 30, 2017 3:10 am
by Jerry B.
I mailed an AT mechanism, thinking it was well packed, and the lower belt pulley was damaged and is unrepairable. I'd like to buy a replacement. Is that pulley common with other Columbia models? Thanks for checking your parts bin.
Jerry Blais
Re: WANTED: Lower Belt Pulley For A Col AT
Posted: Fri Jun 30, 2017 5:41 am
by jboger
I have the lower belt pulley for an AZ. I'll provide dimensions later. Maybe it will fit.
Re: WANTED: Lower Belt Pulley For A Col AT
Posted: Fri Jun 30, 2017 3:11 pm
by jboger
Here are the dimensions: Diameter is 2-⅜ inches. Width is 7/16 inches. The inner hole diameter(for the arbor) is 3/16 inches. I don't have the set screw, but good chance is the same if the pulley is the same.
Re: WANTED: Lower Belt Pulley For A Col AT
Posted: Fri Jun 30, 2017 5:02 pm
by Django
Jerry asked me to post some pictures if the damaged pulley. The flange diameters are 2 5/16", The actual functional pulley diameter is 1 ¼". Width between the flanges is ⅜". Through bore is 3/16". The material appears to be a nickel plated brass casting.