Page 1 of 1
WANTED: mandrel and shaft
Posted: Wed Aug 23, 2017 2:14 pm
by phonocookie
Picked up a Edison Standard C machine and the mandrel and shaft are bad. The bearing was bad and they did a number on it. Anybody have an extra one laying around ? Jerry
Re: WANTED: mandrel and shaft
Posted: Wed Aug 23, 2017 6:12 pm
by flashpanblue
Hi Jerry,
I just bought a partial Edison model D that I am going to part out. It has a decent mandrel with shaft you can have for $20 plus postage. I believe the model D and C share the same mandrel size.
Pete
Re: WANTED: mandrel and shaft
Posted: Thu Aug 24, 2017 8:36 am
by flashpanblue
Jerry,
I need your mailing address ( also sent a P.M.)
Pete
Re: WANTED: mandrel and shaft
Posted: Thu Aug 24, 2017 12:04 pm
by phonocookie
I will take the mandrel and shaft. Thank you for the come back. Jerry from Minn.
Re: WANTED: mandrel and shaft
Posted: Thu Aug 24, 2017 9:06 pm
by mark gaisser
fyi ...the c and the d mandrel shaft are different....the d will work on the d,e and f models....the c will only work on the model c machines and is a very hard mandrel to find.
good luck,
mark