Page 1 of 2

Good Project Brunswick

Posted: Wed Oct 04, 2017 10:24 am
by dutchman

Re: Good Project Brunswick

Posted: Wed Oct 04, 2017 4:16 pm
by ts_13
Dang I would grab that if I were close!

Re: Good Project Brunswick

Posted: Wed Oct 04, 2017 5:03 pm
by dutchman
Me too - it would be about a 8 hour round trip :( Bill K

Re: Good Project Brunswick

Posted: Wed Oct 04, 2017 6:37 pm
by Phonofreak
That's a real early one, circa 1915-16. This originally had a lateral reproducer and a special reproducer for Pathé and Edison. This was upgraded to the Ultona arm after 1917 That's when the Ultona came out. Great price for a scarce machine.
Harvey Krovitz

Re: Good Project Brunswick

Posted: Thu Oct 05, 2017 8:42 am
by dutchman
I'm in touch with the owner, waiting for a couple more photos.

Re: Good Project Brunswick

Posted: Thu Oct 05, 2017 7:21 pm
by Phonofreak
Good luck. I hope you get it. To be honest, at that price, I would jump on it ASAP. It's a pretty early machine with the early decal.
Harvey Kravitz
dutchman wrote:I'm in touch with the owner, waiting for a couple more photos.

Re: Good Project Brunswick

Posted: Fri Oct 06, 2017 11:09 am
by dutchman
Since this would be a 8 hour round trip I asked if they would be willing to meet half way and I would
double their asking price I go a resounding no! Sigh

Bill K

Re: Good Project Brunswick

Posted: Fri Oct 06, 2017 1:38 pm
by ts_13
dutchman wrote:Since this would be a 8 hour round trip I asked if they would be willing to meet half way and I would
double their asking price I go a resounding no! Sigh

Bill K

Go get it! Put some good music on and take a drive!

Re: Good Project Brunswick

Posted: Sat Oct 07, 2017 2:38 pm
by dutchman
ts_13 wrote:
dutchman wrote:Since this would be a 8 hour round trip I asked if they would be willing to meet half way and I would
double their asking price I go a resounding no! Sigh

Bill K

Go get it! Put some good music on and take a drive!
I took your advice TS and it is now residing in the back of my Tundra waiting for someone to help me get it out....

Bill K

Re: Good Project Brunswick

Posted: Sat Oct 07, 2017 5:34 pm
by ts_13
dutchman wrote:
ts_13 wrote:
dutchman wrote:Since this would be a 8 hour round trip I asked if they would be willing to meet half way and I would
double their asking price I go a resounding no! Sigh

Bill K

Go get it! Put some good music on and take a drive!
I took your advice TS and it is now residing in the back of my Tundra waiting for someone to help me get it out....

Bill K

There you go! Good job!!!!!!

See just a little gas money.....