Page 1 of 2

Wayne Show Photos

Posted: Sat Oct 07, 2017 5:30 pm
by Jerry B.
I spent about three hours at the parking lot of the Wayne Show. Here are a few photos of my day.

Re: Wayne Show Photos

Posted: Sat Oct 07, 2017 5:47 pm
by melvind
I am envious beyond belief! Have fun tomorrow!

Re: Wayne Show Photos

Posted: Sat Oct 07, 2017 7:25 pm
by Phonofreak
Hey Jerry, What treasures are you bringing back?
Harvey Kravitz

Re: Wayne Show Photos

Posted: Sat Oct 07, 2017 8:22 pm
by Steve Levi
Thanks for the photos! Steve

Re: Wayne Show Photos

Posted: Sat Oct 07, 2017 10:24 pm
by travisgreyfox
Thanks. I guess I just have to live vicariously through pictures since I cant make it there. :(

Re: Wayne Show Photos

Posted: Sun Oct 08, 2017 12:53 am
by maginter
How much was the Columbia Mignon? I had on, an wouldn't might getting another? Who had it?

Re: Wayne Show Photos

Posted: Mon Oct 09, 2017 5:09 am
by Jerry B.
Hey Jerry, What treasures are you bringing back?
Harvey Kravitz
My big purchase was the sketch done by Caruso. I am delighted with that purchase. Thanks Steve M. very much! :D

Jerry Blais

Re: Wayne Show Photos

Posted: Mon Oct 09, 2017 5:33 am
by Jerry B.
The Wayne show offers much more than just being a very good phonograph sale. The Edison sites at Menlo Park and West Orange, NJ are very close to Wayne (probably 45 minutes). These few photos give you an taste of the history located nearby.

Jerry Blais

Re: Wayne Show Photos

Posted: Mon Oct 09, 2017 11:45 am
by fmblizz
Wish I could have made the show.. Thanks for the pictures Jerry, now off to the chiropractor... :lol: :lol:

blizz

Re: Wayne Show Photos

Posted: Mon Oct 09, 2017 5:31 pm
by edisonphonoworks
Some interesting machines for sale, I have not run into a Victor motor with the springs off to the right, and that gear arrangement. In the Edison museum phontos Photo #1338 has a special record I made for those early machines following a formula in the Aylsworth notebook, it is of stearic, ceresin, and carnauaba wax. . #1341 is a recording phonograph, this was standard equipment, in Edison's studio, and if you note the chain driven feedscrew in the back, that is the four minute master gearing for which Edison Amberol, and Blue Amberol masters were cut with. 194.667 tpi. (97 ⅓ tpi, and the reduction gear of 8 teeth, while the feedscrew has 16 teeth.