Page 1 of 1
WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 1:29 pm
by Wes K
I am in need of two corners for a Victor III. I need two center parts and one top.
Thanks
Wes
IMG_0667.JPG[/attachment
[attachment=1]IMG_0666.JPG
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 2:07 pm
by Crank_it_up
I'm pretty sure that George Vollema has these parts at Great Lakes Antique Phonographs. His contact info is in the "Links" section on this forum
Good Luck!
Joe
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 2:07 pm
by alang
George Vollema makes really nice replacements:
http://www.victroladoctor.com/cabinet-parts/
Andreas
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 2:11 pm
by Jerry B.
Does your ID tag say III? It looks like a Victor M to me. Jerry
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 2:24 pm
by JerryVan
Jerry B. wrote:Does your ID tag say III? It looks like a Victor M to me. Jerry
Me too.
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 3:38 pm
by Wes K
Yes it is an M.
I would like to find some originals before I go the the reproduction route.
Re: WANTED: Corners for Victor III
Posted: Fri Feb 16, 2018 4:44 pm
by Jerry B.
If the machine were mine I would tap off enough parts to complete the columns in the front and use replacements, whether original or reproduction, at the back. Even original replacements will probably be a little off in finish due to different environmental conditions over the years. Good luck with your project.
Jerry Blais
Re: WANTED: Corners for Victor III
Posted: Sat Feb 17, 2018 12:06 pm
by Phonolair
Direct email sent
Larry Crandell