The Talking Machine Forum — For All Antique Phonographs & Recordings

I am in need of a nice looking crank for a table model Victrola X.
Thanks!
Dave D

Hi Dave-- Any dimensions you can share? I've got lots of cranks-- I assume this is an early female crank??

Brad Abell

Here are a couple of photos. The crank looks awful and the owner of this would like a nice one. The Victrola was his great grandfather's and languished in a shed for many years. The rest of the metal is going to clean up ok, but the crank is too far gone.

Thanks for looking!

Hi Dave- We may have a winner-- The shaft on mine is 6 ⅝"-- yours looks like 6 ½, but may just be how we measured. Take a look and see what you think- It's not pristine-- has some nickel loss, but looks better than the one you're replacing to my eyes. I tried to picture it to show the rough spots.

Brad

Hi Dave,
Can I please buy the old crank.
Blain