Page 1 of 1
WANTED: Part of an XVI pull-out tray
Posted: Sun Mar 11, 2018 7:48 pm
by GregVTLA
Hello! My Victrola XVI pull out tray is broken at the back and no longer is stopped from falling too far into the cabinet. If anyone had one that was broken up, busted, or otherwise useless, but with a good back piece, feel free to send a PM.
Re: WANTED: Part of an XVI pull-out tray
Posted: Sun Mar 11, 2018 10:21 pm
by Victrola-Monkey
You could just replace the tray, there’s two of them real cheap right now on Ebay in Florida for only $10 and $17... And then there’s that third one for $100.
Re: WANTED: Part of an XVI pull-out tray
Posted: Mon Mar 12, 2018 7:03 am
by GregVTLA
You’re proBably right about that, I’ll take a look at those.
Greg