WANTED: Gear & Clip for 4-Spring 3-Bolt Mount Motor
Posted: Mon Apr 23, 2018 7:07 pm
Does anyone have to sell an extra gear (circled below in 1st photo) and retaining clip (measurements given below in 2nd photo) that goes in the crank handle area of a late model 4 spring Victrola motor (3 mounting bolt type)? I have a nice winding motor that without this clip and a gear that actually has some teeth on it, will unwind the crank handle on me. A dangerous situation.
Or if you got these parts and want to buy this motor, it's a good one. Can send a link of it being wound up and unwinding (while firmly holding the crank in place).
I have another similar motor with a good gear and clip and these parts on it can be seen in the 3rd photo below.
Thanks.
Or if you got these parts and want to buy this motor, it's a good one. Can send a link of it being wound up and unwinding (while firmly holding the crank in place).
I have another similar motor with a good gear and clip and these parts on it can be seen in the 3rd photo below.
Thanks.