The Talking Machine Forum — For All Antique Phonographs & Recordings

I need springs but they are not 2". I replaced them with 2" but they only cause the motor to stop from too much pressure.

I have 2 good ones but the third snapped. I will need all 3 springs and weights as these are riveted on and I dont want to drill them out for screws. If no one has the set but has the right length springs I will try to drill the rivets out..

Here is what I have.

I'd suggest Ron Sitko and get a matching set of three weights and springs. Jerry Blais

Thanks,
I just talked to him and he is going to take care of it if he has them.
Kirk