Page 1 of 1
VV2-35
Posted: Wed May 09, 2018 4:55 pm
by Estey Organ
Any tricks of the trade for getting the turntable off a VV2-35 off?
Persuasion?
Screwed on? Lift off like a normal turntable?
Thanks in advance .
Re: VV2-35
Posted: Wed May 09, 2018 9:05 pm
by OrthoFan
If you don't see a round flat-spring clip holding it in place, there might be a hole in the spindle, itself. In that case, insert a nail or whatever in the spindle, and holding the turntable, turn the spindle to unscrew.
I don't think the 2-35 had a locking screw under the turntable accessed with a very long screwdriver, as some of the mid to late 1930s (off brand) models I've come across did.
Hope this Helps***
OrthoFan
***(But, if you don't respond to this post, I'll never know
)
Re: VV2-35
Posted: Sat May 19, 2018 12:41 am
by Estey Organ
I found a clip underneath the parapet on the turntable table!
Got it going, the Governor stopped chattering by lubricatong through the holes in the bed plate.
But, the speed is u steady, so I’m ready to take the bed plate out to the case, but one screw is not cooperating! Even bent a good screwdriver trying. Argh!