Page 1 of 1
How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 9:16 pm
by JAR
Anyone ever done Edison Diamond Disc edge repair.
JAR
Re: How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 9:22 pm
by Wolfe
"Edge repair" is vague.
If you mean a disc where the celluloid surface has peeled / warped / separated away from the core, I'm not aware of any fix for that.
Re: How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 9:53 pm
by Curt A
If the edge is complete, but just separated or delaminated, Weldbond glue works good to permanently put it back together. You can get it at Michaels or online... It it has a piece missing, then it would depend on how large and deep it is... a picture would definitely help.
Re: How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 10:01 pm
by JAR
There was a post on FaceBook, but no additional info.
Re: How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 10:33 pm
by donniej
It was an edge chip that was close, but not into the grooves. I suggested filling it with low viscosity super glue and cleaning up with 1000 grit or finer sandpaper. Unlike shellac, DD's can have a little bit of excess glue cleaned off with acetone, if necessary.
Re: How do you do Edison Diamond Disc edge repair.
Posted: Thu Jun 21, 2018 10:38 pm
by JAR
Thanks for the information.
Jerry