Page 1 of 1

FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sat Sep 29, 2018 4:35 pm
by mattrx
I have tried to source the parts for this machine, but have had very little luck. http://forum.talkingmachine.info/viewto ... =9&t=36762

Therefore, I have decided to part out the machine if there is interest or sell the entire machine to anyone that thinks they can restore it.

For sale is:

Case ($20 + shipping)
Motor board and working (smooth) motor (this motor is very similar to the Vic III motor of similar vintage) ($90 + shipping)
Tone arm bracket, beauty ring and arm, ($35 + shipping)
Lid hinge-if not sold with case ($10 + shipping)
Turntable with original felt-will clean up nicely ($15 + shipping)
Anything else shown in the pics-inquire or make an offer.

Thanks,

Matt

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sat Sep 29, 2018 5:13 pm
by GregVTLA
Are you selling the improved concert?

Greg

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sat Sep 29, 2018 6:41 pm
by mattrx
That wasn’t the plan. Thanks though.

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sat Sep 29, 2018 6:43 pm
by mattrx
That wasn’t the plan. Thanks though. Unfortunately the thumb screw is sheared off and I need to get it removed. It was very brittle.

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sat Sep 29, 2018 6:48 pm
by Kirkwood
I'd like that turntable, if I'm not too late already. PM en route.

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Mon Oct 01, 2018 9:07 pm
by mattrx
Turntable sold.

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Sun Oct 07, 2018 8:42 pm
by mattrx
Bump

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Mon Apr 22, 2019 3:30 pm
by CDBPDX
Are these parts still available? I would be interested in the motor and motor board.

Thanks! Cliff

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Mon Apr 22, 2019 3:38 pm
by studebakerphonos
PM Sent

Re: FOR SALE: Parting Out VV-IX (Early) - VARIOUS

Posted: Tue Apr 23, 2019 12:06 am
by mattrx
PM's sent to Cliff and Bob.
Thanks!