The Talking Machine Forum — For All Antique Phonographs & Recordings

Posted: **Mon Oct 29, 2018 6:06 pm**

I picked up a Victor II with no horn today. Can anyone tell me the diameter of the elbow where it fits into the casting? I am not sure if this is a cobble job or not. By the way, this is not the later slip in elbow.
Thanks in advance.
Dave

Posted: **Mon Oct 29, 2018 9:06 pm**

Hi Dave

Small end of the elbow that fits into the back bracket is 1.5 " OD

Larry Crandell

Posted: **Tue Oct 30, 2018 6:16 am**

Hi Larry,
Thanks for taking the time to help me with this. I sent you a PM.
Dave

The Talking Machine Forum — For All Antique Phonographs & Recordings

Elbow diameter of Victor II info needed

Elbow diameter of Victor II info needed

Re: Elbow diameter of Victor II info needed

Re: Elbow diameter of Victor II info needed