Page 1 of 1
FOUND: GOVERNOR SPRINGS FOR PORTABLE PHONOGRAPH
Posted: Wed Nov 21, 2018 7:26 pm
by pellicano1
Question, do any of you machinists on here able to make governor springs? I need a set of 3. The spring measures 1 ¾" long x ¼" wide. The screw holes are ⅛" on center from end of spring. I do not have a multi-meter to measure thickness. Anyone? My portable Triumphon sits silently
Re: WANTED: Governor Spring for Portable Phonograph
Posted: Wed Nov 21, 2018 8:22 pm
by Jerry B.
It is really important to have a matched set. I would suggest you send one of your good springs to Ron Sitko and ask for a new set of three. It's a small investment and you'll be much happier.
Jerry Blais
Re: WANTED: Governor Spring for Portable Phonograph
Posted: Tue Nov 27, 2018 8:20 pm
by pellicano1
Jerry B. wrote:It is really important to have a matched set. I would suggest you send one of your good springs to Ron Sitko and ask for a new set of three. It's a small investment and you'll be much happier.
Jerry Blais
Ron Sitko is off until January. I know he is the go to for parts!! Thanks for the info.