Page 1 of 1

Upright (Unknown Name)

Posted: Sun Dec 02, 2018 11:31 am
by dutchman
https://washingtondc.craigslist.org/nva ... 94051.html

About 20 minutes from me - No room :) Bill K

        Re: Upright (Unknown Name)

        Posted: Mon Dec 03, 2018 1:03 am
        by travisgreyfox
        Wow that is neat looking. You are selling your house short, i'm sure you can squeeze this in there someplace :)

        The seller says, "I have not cranked it up" that is code word for "I have cranked it and it did not work".

        Re: Upright (Unknown Name)

        Posted: Mon Dec 03, 2018 9:17 am
        by dutchman
        travisgreyfox wrote:Wow that is neat looking. You are selling your house short, i'm sure you can squeeze this in there someplace :)

        The seller says, "I have not cranked it up" that is code word for "I have cranked it and it did not work".

        :lol: Exactly "I lost the crank is another red flag" :D I may check on this later today and then plead it would be a nice
        stocking stuffer......My wife suggested renting a storage unit, not good! Bill K

        Re: Upright (Unknown Name)

        Posted: Mon Dec 03, 2018 1:32 pm
        by epigramophone
        This may be a British made machine, as there was a fashion over here for barley twist legs on cabinets in the late 1920's.
        The Beltona pictured bottom right below is a typical example.

        Re: Upright (Unknown Name)

        Posted: Fri Dec 07, 2018 10:37 pm
        by jboger
        Still listed for $100. Listing states the machine has an English Maxitone tone & reproducer arm.

        Re: Upright (Unknown Name)

        Posted: Sat Dec 08, 2018 5:46 am
        by epigramophone
        Yes the machine could be a Maxitone, what Americans call an "off brand" and we in the UK call an "assembled" gramophone i.e. assembled from bought in components.

        Re: Upright (Unknown Name)

        Posted: Sun Dec 09, 2018 9:13 am
        by oltractor
        i like this wish it was was a little closer to me

        Re: Upright (Unknown Name)

        Posted: Sun Dec 09, 2018 9:43 am
        by dutchman
        oltractor wrote:i like this wish it was was a little closer to me

        I wish I had more room :D I noticed the top(lid) does not appear to fit right. Bill K