Page 1 of 2
Need ID on this machine.
Posted: Fri Dec 14, 2018 3:16 pm
by dutchman
Stumbled across this little machine at a local antique shop today. Its 23 inches high, has a Columbia reproducer, winds and runs ok and is definitely heavy. Cabinet has no markings other than the circular decal on the door. Thanks Bill K
Re: Need ID on this machine.
Posted: Fri Dec 14, 2018 6:02 pm
by Phonofreak
This looks like a Carryola(spelling). This was a small metal upright machine. There was a painted whit or yellow with children's designs for kids. The Columbia reproducer is a later addition. I'm not sure what the original reproducer looks like, nor the manufacturer.
Harvey Kravitz
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 9:07 am
by dutchman
Thanks - this thing is wood. The shop has a price of $360 on it. Bill K
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 9:35 am
by epigramophone
Could it be something like this?
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 10:23 am
by dutchman
Here is the decal on the outside of the door - Bill K
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 5:43 pm
by cjstoessner
I'm no expert... but I don't think it is a Carola, I think they were usually metal, made to "look" like wood grain. I will research a little and see if I can find an old advertisement of your machine, it looks kind of familiar to me like I may have seen one like it somewhere else, online or in a book, but painted white....
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 5:53 pm
by gramophone-georg
I think it's a General Phonograph Company "Deluxe" Model- probably the same as Genola.
Stan's site (clarphon.com) has a very similar machine in white second from the bottom on this page:
http://www.clarphon.com/childrenphono.htm
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 5:58 pm
by cjstoessner
I agree with the above post....
Re: Need ID on this machine.
Posted: Sat Dec 15, 2018 6:31 pm
by dutchman
Thanks for the info. I asked the shop what his best price was, he said he would knock $100 off---that reduced the price to $295

Can anyone identify the decal on the door? I've seen this decal before but for the life of me cannot remember where. Thanks again. Bill K
Re: Need ID on this machine.
Posted: Tue Dec 18, 2018 5:17 pm
by dutchman
I found another one of these on a website - it is identical to the one I posted here including the decal, etc. I may make an offer on this machine but I believe the owner has another machine in the shop----a Victor Credenza for the small sum of $625. I haven't a clue what these child machines go for but he came off the original price of $395 down to $295. I may throw another bid out there and see what happens but I hate to go into this blind not knowing the going rate for these or similar machines. Cheers Bill K