Page 1 of 1
WANTED: Mandrel/Shaft For Edison Model D Standard
Posted: Wed Mar 20, 2019 6:33 pm
by Phonofreak
A buddy of mine is looking for and Edison mandrel and shaft for a Model D Standard. The shaft is bent. If a complete assembly is not available, then just the shaft will be fine. He can swap the shaft. Any leads will be great.
Thanks in advance,
Harvey Kravitz
Re: WANTED: Mandrel/Shaft For Edison Model D Standard
Posted: Wed Mar 20, 2019 7:14 pm
by Jerry B.
Could that shaft be straightened? I realize it would need to be perfect to avoid issues. I'd check with the famous Ken Brekke.
Jerry B.
Re: WANTED: Mandrel/Shaft For Edison Model D Standard
Posted: Fri Mar 22, 2019 6:44 pm
by Phonofreak
Still looking for the mandrel/shaft for the Edison Model D Standard. Any leads greatly appreciated.
Harvey Kravitz
Re: WANTED: Mandrel/Shaft For Edison Model D Standard
Posted: Sat Mar 23, 2019 1:13 pm
by studebakerphonos
Harvey,
I believe I purchased a reproduction one form Ron Sitko a while back.
Kind Regards, Bob
Re: WANTED: Mandrel/Shaft For Edison Model D Standard
Posted: Sat Mar 23, 2019 8:47 pm
by Phonofreak
Thanks, I'll tell my buddy to check with Ron.
Harvey Kravitz