Page 1 of 1
FOUND: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Tue Jul 23, 2019 10:51 pm
by erunltd
I am in need of the gear that drives the governor of an
Opera mech. The fibre gear typically goes bad and needs
to be replaced. A replacement gear can come from a parted
out Amberola B1, Amberola III or an Opera. If you have
this gear that you can part with, let me know. See photo
Thanks for looking, Harry
Re: WANTED: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Wed Jul 24, 2019 5:39 am
by Phono-Phan
Search for Ron Sitko in the Links section.
Re: WANTED: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Wed Jul 24, 2019 11:21 am
by phonojim
Ron does have them for the Opera.
Jim
FOUND: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Wed Jul 24, 2019 12:24 pm
by erunltd
phonojim wrote:Ron does have them for the Opera.
Jim
Thanks Jim . . . I will check with Ron.
Re: FOUND: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Wed Jul 24, 2019 9:00 pm
by Phono-Phan
Harry,
Check out my post of my Opera gear repair:
http://forum.talkingmachine.info/viewto ... ar#p236676
I was able to repair the fiber gear and it has worked well for the last 25 plus years.
Ken
Re: FOUND: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Sat Jul 27, 2019 3:06 pm
by EdisonWizard
Seeing this makes me want to buy a fibre gear just to have as a spare!
Re: FOUND: FIBRE OR BRASS GOVERNOR DRIVE GEAR FOR OPERA
Posted: Sat Jul 27, 2019 5:22 pm
by erunltd
This is a great idea . . . I need to try it. The creative ideas make
restoration the best part of this hobby. Thanks for the tip. Of course,
I ordered a brass gear just to have it on hand. It is not offered as fiber.
Thx