Page 1 of 1
WANTED: Limit Screw for Brass Orthophonic Reproducer & Info
Posted: Tue Sep 01, 2020 3:46 pm
by JerryVan
Could use 2 of the tiny limit screws & nuts that prevent over-travel of the needle bar. I need the ones for the brass Orthophonic reproducers only, (the ones used on the pot metal versions are larger).
Would also like to know the thread size of these screws.
Thanks!
Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I
Posted: Thu Sep 03, 2020 12:11 am
by phonojim
I'll try to check my stock of Ortho parts tomorrow. I think I have some but I'm not sure.
Jim
Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I
Posted: Thu Sep 03, 2020 6:15 pm
by JerryVan
phonojim wrote:I'll try to check my stock of Ortho parts tomorrow. I think I have some but I'm not sure.
Jim
Thanks Jim!
Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I
Posted: Fri Sep 04, 2020 12:43 am
by phonojim
I have one. Check your PMs.
Jim