Page 1 of 1
Used needle pot for HMV 157
Posted: Thu Sep 03, 2020 5:37 am
by Phono48
Can onyone sell me a needle pot for an HMV 157 upright cabinet machine? They are fitted to many of the cabinet and table models. It's for used needles, straight sided with a slightly concave removeable top, nickel plated.
Barry
Re: Used needle pot for HMV 157
Posted: Thu Sep 03, 2020 6:46 am
by Orchorsol
I have one here you'd be welcome to Barry, but it's taller than some HMV ones (about 26mm) - you're welcome to it if it suits!
Andy
Re: Used needle pot for HMV 157
Posted: Thu Sep 03, 2020 1:16 pm
by Phono48
Orchorsol wrote:I have one here you'd be welcome to Barry, but it's taller than some HMV ones (about 26mm) - you're welcome to it if it suits! Andy
Very kind of you, Andy, but it's too tall. The hole in the motor board is 10mm deep, so with the lid, I reckon the one I need would be around 12-15mm deep in total. Thanks, though.
Barry
Re: Used needle pot for HMV 157
Posted: Fri Sep 04, 2020 5:22 am
by soundgen
Re: Used needle pot for HMV 157
Posted: Fri Sep 04, 2020 8:37 am
by Gramtastic
Hi Barry,
I've got one you can have. Send me a private message with your address and I'll post it.
Andrew
Re: Used needle pot for HMV 157
Posted: Fri Sep 04, 2020 1:09 pm
by Phono48
Gramtastic wrote:Hi Barry,
I've got one you can have. Send me a private message with your address and I'll post it.
Andrew
Thanks Andrew, PM sent with details.
Barry