Page 1 of 1
FOUND: Columbia Motor Board Nut.
Posted: Tue Sep 21, 2021 8:34 pm
by cweastlick
I picked up a little Columbia Grafonola and it is missing the small knurled nut that holds the motor board shut like shown in the picture below. It needs a crank as well. Let me know if you have one to sell.
Thanks!
Charles
Re: WANTED: Columbia Motor Board Nut.
Posted: Wed Sep 22, 2021 6:57 pm
by Phono-Phan
I think I have one. It came off a table top Columbia so I believe the thread size is correct. You can have it for the cost of shipping. I just mailed out a thumbscrew for a Victrola #2 reproducer and it wouldn't go regular mail because it didn't fit through the USPS guage. I had to send it Parcel Post in a padded mailer. I would have to send this the same way. So just send what the postage is on the package. Send me your mailing address and I can get it sent.
Glad to help!!!
Ken Brekke
Re: WANTED: Columbia Motor Board Nut.
Posted: Thu Sep 23, 2021 10:06 am
by cweastlick
PM sent.
Re: FOUND: Columbia Motor Board Nut.
Posted: Sat Sep 25, 2021 5:57 pm
by cweastlick
Thank you Ken Brekke. Fits perfectly!!
Re: FOUND: Columbia Motor Board Nut.
Posted: Wed Sep 29, 2021 7:13 pm
by Phono-Phan
Great!!! Glad to help.