The Talking Machine Forum — For All Antique Phonographs & Recordings

This isn't a phonograph item but I thought perhaps someone would know the technique.

I've broken a piece of cast metal (probably aluminum alloy) kitchen equipment- part of a 1950'a Mixmaster. Can this be mended with epoxy? It doesn't have to be pretty, just strong. The part doesn't move or bear weight but it stabilizes and prevents shaking- if you've got a vintage mixmaster this is the foot of the Power Takeoff Unit. I've bought a replacement on Ebay but would like to get this one into operable shape.

JB Weld is a good product. You might give that a try. Jerry

I will look for some- it doesn't have to be perfect, just work.

I had a cracked lower unit, apparently also aluminum alloy, on my previous outboard motor. A local welding shop was able to repair it. Might be worth a try to visit some shops in your area with the piece in hand and seek opinions.

(P.S. estott, I think you may be near me in PA. The welding shop was Nash Welding on Walbert Ave. in Allentown.)

Thanks but this piece is not worth repairing by welding as I have a replacement coming- I just need a quick fix.

UPDATE: I cleaned the unit with lacquer thinner and used JB Kwik to reattach the broken foot. It set up just fine and a short while ago I fitted it into the Mixmaster and gave it a brief test- it works! No chattering and vibration, the unit holds steady. I'll let it set overnight before I really give it a workout. An unbroken replacement is in the mail but this will at least be a backup.