Page 1 of 1
WANTED Orthophonic Reproducer
Posted: Wed Dec 08, 2021 2:28 pm
by MTPhono
Looking for a good orthophonic reproducer. What have you got?
Re: WANTED Orthophonic Reproducer
Posted: Thu Dec 09, 2021 5:51 pm
by chrisg
Got this. 45 bucks shipped to you. Needs rubber insert. I can send video of it playing if interested at all
Re: WANTED Orthophonic Reproducer
Posted: Thu Dec 09, 2021 8:37 pm
by phonojim
I have one which I will post later tonight as soon as I can check it out and take pictures.
Jim
Re: WANTED Orthophonic Reproducer
Posted: Thu Dec 09, 2021 10:52 pm
by phonojim
Here is my offering: potmetal Orthphonic reproducer, no cracks, swelling or chipping. The needle bar pivot bearings have been cleaned, lubed and new rubber cushions installed. I believe I changed the diaphragm gaskets at the same time but I am not certain of that. The rubber isolator has also been replaced. It plays very well without distortion and gives good sound. There is wear to the gold finish especially around the edge but overall presents well. The price is $75.00 plus shipping, most likely via Priority Mail.
Re: WANTED Orthophonic Reproducer
Posted: Fri Dec 10, 2021 1:14 pm
by emerson
Are you looking for a gold, brass reproducer?
Re: WANTED Orthophonic Reproducer
Posted: Fri Dec 10, 2021 6:33 pm
by outune
Hi Scott- I'll send you a PM with a couple pictures.
Brad Abell
Re: WANTED Orthophonic Reproducer
Posted: Mon Dec 20, 2021 11:52 pm
by MTPhono
emerson wrote: Fri Dec 10, 2021 1:14 pm
Are you looking for a gold, brass reproducer?
Yes, the brass colored example.