The Talking Machine Forum — For All Antique Phonographs & Recordings

Here's an original Victor Z that needs a reproducer, horn and travelling arm. This has a nice original finish, has the desirable early 8-inch beveled cast iron turntable, motor works well (click on the video below {MPG file} to see it working), original Victor sticker is on the bottom board. The crank has a couple of splits at the slot but it works. The cabinet has a small hole just under the motor board near one hinge (see picture). It's not easily seen and, in fact, I didn't notice it until many months after buying this and it has never bothered me at all. The ratchet gear may need some attention as it has a couple of worn teeth but I've not had a problem with cranking it up so far. I borrowed a travelling arm, horn and reproducer from one of my other front mount Victors and temporarily installed them on this and it plays through an 8-inch record and a 10-inch record just fine. That's about it. If you're looking for a Victor Z that needs a little help and a few parts then this may be one to consider.

PM, PayPal Friends or check, USPS shipping is extra at cost. Packaged securely.

Thanks,
Doug

New price and includes shipping to continental USA address.

Doug