Broken Screw Problem and Tonearm Part
Posted: Thu Mar 03, 2022 8:12 pm
I posted this in machines and have reposted it in here to see if there are any other solutions.
I recently started working on a Victor III I got for a good price but is in poor condition. I noticed that one of the set screws for the governor bearing was missing. Upon further inspection, I noticed that the screw had snapped in half and is stuck in the casting. My question is how should I go about removing this screw without damaging anything? Any help would be appreciated.
Also, i'm listing all the parts that are missing and I am trying to determine wether the back bracket is missing a support ring. I see some pictures online with it and some without it. Is it normal for some brackets to not have it?
Any help is appreciated.
I recently started working on a Victor III I got for a good price but is in poor condition. I noticed that one of the set screws for the governor bearing was missing. Upon further inspection, I noticed that the screw had snapped in half and is stuck in the casting. My question is how should I go about removing this screw without damaging anything? Any help would be appreciated.
Also, i'm listing all the parts that are missing and I am trying to determine wether the back bracket is missing a support ring. I see some pictures online with it and some without it. Is it normal for some brackets to not have it?
Any help is appreciated.