The Talking Machine Forum — For All Antique Phonographs & Recordings

I am looking for the short shaft that goes on the Victor Gen 1 changer for the record size indexer. If you have a part or dimensions, please let me know.

TIA

Mark,

Here are some dimensions. It is a simple ⅜” shaft with one end turned down to ¼” and contains two 3/32” holes for the cross pins that secure the two bevel gears.

I have these dimensions on hand because of an ongoing project to make replacement index assemblies available later in the year. Mark

Mark -

Thank you so much. This is very helpful and exactly what I needed.

Thanks Again!

Mark

Hi Mark,

I was able to finish this up this morning and mail it. I hope it solves your problem. My gift to you.

Mark