SOLD: Columbia AT Cylinder Graphophone - $230 shipped
Posted: Sun May 15, 2022 5:40 pm
SOLD
$230 includes shipping in the USA, insurance, with signature confirmation, via USPS Ground
The motor runs quite. The carriage glides smoothly. The reproducer needs a rebuild and a stylus. I tested a record by holding an Edison C reproducer against the carriage, it tracked and the vocal was steady, no flutter. The speed control knob is not authentic, but works. The reproducer lift clip is needed, instead of the wrapped wire.
The exterior of the lid is very nice. The interior could use a patch.
The case needs two rear columns. The base moulding is chipped at bottom left of front. The corners of the bedplate seat all have gaps. The thin covering at the bottom of the case needs a glue and patch.
That is all that is obvious to me.
Thanks for looking,
James.
$230 includes shipping in the USA, insurance, with signature confirmation, via USPS Ground
The motor runs quite. The carriage glides smoothly. The reproducer needs a rebuild and a stylus. I tested a record by holding an Edison C reproducer against the carriage, it tracked and the vocal was steady, no flutter. The speed control knob is not authentic, but works. The reproducer lift clip is needed, instead of the wrapped wire.
The exterior of the lid is very nice. The interior could use a patch.
The case needs two rear columns. The base moulding is chipped at bottom left of front. The corners of the bedplate seat all have gaps. The thin covering at the bottom of the case needs a glue and patch.
That is all that is obvious to me.
Thanks for looking,
James.