Page 1 of 1
Wanted: Small Bolts/screws for Victor Spring Barrel
Posted: Mon Jun 27, 2022 11:02 pm
by mattrx
I am in need of a few of the smaller bolts/screws that hold the cap on the spring barrel of certain victor motors. The motor I have also uses these same screws to hold the spring barrel cover in place. I need about 8 of these, but will take what I can get.
See the items circled in red on the attached photo.
Thanks,
Matt
- E0FDA460-50A6-4CCE-9B64-69212D9ECB93.jpeg (102.56 KiB) Viewed 369 times
Re: Wanted: Small Bolts/screws for Victor Spring Barrel
Posted: Mon Jul 04, 2022 12:36 am
by mattrx
Bump....Does anyone have any of these for sale? I'll gladly buy them from you or trade for something you want. Thanks in advance for a response.
Matt
Re: Wanted: Small Bolts/screws for Victor Spring Barrel
Posted: Mon Jul 04, 2022 3:33 am
by JeffR1
What size are they, 4-40, 6-32 ?
They're too small for a number 8, and too big for a 2 or 3.
Could be a 5-40, but that size isn't used much anymore, but who knows back then.
I get all my odd stuff from Fastenal, they have a US outlet too.
They are a whole sale dealer so they expect to sell you in bulk, but it's not expensive, and the quality is there verses the junk at the hardware store.
Pan head:
https://www.fastenal.ca/counterBook/Fas ... tId=600059
Fillister:
https://www.fastenal.ca/counterBook/Fas ... tId=600059
They have cheese head too, but only in metric.
Maybe that's your problem, you don't know the size, if I had a sample I could measure the thread and tell you.
McMaster-Carr only has metric in cheese head as well _ very odd.