The Talking Machine Forum — For All Antique Phonographs & Recordings

Ok now I’m back working on my B-19 machine, for some reason only one screw was left holding the pawl to the motor frame when there should have been four.

Does anybody have a full set or at least 3 winding pawl screws?

Thanks as always!

I think you're looking for the screws that attach the winding shaft bracket?

IIRC, you need to be a bit careful with this because the four screws are not the same. The two "front" ones are, as are the two "back" ones, but the "Front" and "back" are slightly different lengths.

JerryVan wrote: Thu Jun 30, 2022 3:51 pm I think you're looking for the screws that attach the winding shaft bracket?

Yeah that’s what I’m looking for.

Ok. I ordered some screws that could possibly fit (2 larger and 2 smaller ones) but not ready to put found yet