Page 1 of 1
WANTED…Victor II horn elbow
Posted: Tue Nov 01, 2022 4:10 pm
by Flying Dutchman
Hello all! I am looking for an early Victor II humpback style horn elbow. The style I am looking for is the type held in with the “Y” clip and screw NOT the slip in style. The diameter of the collar that rests in the rear bracket is 1.5”.
Not looking for a reproduction. You can PM me or contact me with any method available. Thank you for any help!!!! Mike
Re: WANTED…Victor II horn elbow
Posted: Tue Nov 01, 2022 5:05 pm
by Jerry B.
I understand the desire for original but Ron Sitko, and I assume Brian Parlier, sells Victor elbows that look like originals and at a fair price. I would avoid the replica aluminum elbows that are still being sold.
Jerry B.
Re: WANTED…Victor II horn elbow
Posted: Tue Nov 01, 2022 5:30 pm
by Flying Dutchman
Thank you Jerry. I’ve been thinking about the replica. I wish I could see one on a machine like mine..
The only other replica I’ve personally seen was horrible. It wasn’t thin like an original. It was chunky and thick..
Re: WANTED…Victor II horn elbow
Posted: Tue Nov 01, 2022 8:02 pm
by chrisg
Brian are just like the originals. Just undamaged . Here is one of his elbows
Re: WANTED…Victor II horn elbow
Posted: Wed Nov 02, 2022 4:01 pm
by outune
Will send PM
Brad Abell
Re: WANTED…Victor II horn elbow
Posted: Wed Nov 02, 2022 7:10 pm
by Flying Dutchman
Thank you all for the help! I think I know the direction I must go.
FOUND…Victor II horn elbow
Posted: Mon Dec 19, 2022 5:37 am
by Flying Dutchman
Found one! Thank you