Page 1 of 1
Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 5:18 am
by colmike1
Not getting any response in the Tips section, so I will try here.
I am wanting to add a cygnet horn to my Edison Triumph model a. It is already been converted to two and four minute. I was wondering if anyone would happen to have a template to help me position the bracket on the back of the machine? Thanks in advance.
Mike Wohl
Re: Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 7:10 am
by dzavracky
I could send you the measurements I used to add my cygnet to a model B triumph. But those probably wouldn’t be the same right?
David
Re: Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 8:28 am
by colmike1
Thank you, David. No, mine hase the early style case with the banner decal, so I don't think it will be the same.
Mike
Re: Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 5:59 pm
by Pete Stratford
I don’t have a template but can offer some pictures
Re: Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 6:00 pm
by Pete Stratford
If you tap on the pictures they will rotate to correct positions and enlarge.
Pete
Re: Template for cygnet bracket on a Triumph Model A
Posted: Fri Dec 02, 2022 10:53 pm
by Jerry B.
A Triumph Cygnet bracket is larger than ones used on Firesides, Standards, and Homes. Mike, are you mounting a Triumph bracket on your Triumph? (I only ask because the smaller bracket is plenty strong and would do the job just fine but the mounting position would be different.)
Jerry B.
Re: Template for cygnet bracket on a Triumph Model A
Posted: Sat Dec 03, 2022 9:45 am
by colmike1
Pete, thank you, those pictures really help. Jerry, yes I am using a Triumph bracket. Thank you for the photos you texted last night. That should do the trick.
Mike Wohl