Page 1 of 1
FOUND: 7" VICTOR TURNTABLE PLATTER
Posted: Tue Mar 21, 2023 11:49 pm
by erunltd
The title tells the story.
I could actually use two platters.
Thx for looking
Re: WANTED: 7" VICTOR TURNTABLE PLATTER
Posted: Wed Mar 22, 2023 11:48 am
by Phono-Phan
Harry,
I think I have one. Let me do some digging.
Ken Brekke
Re: WANTED: 7" VICTOR TURNTABLE PLATTER
Posted: Wed Mar 22, 2023 11:59 am
by Kevin Clark
Have some as well.
Re: FOUND: 7" VICTOR TURNTABLE PLATTER
Posted: Wed Mar 29, 2023 4:21 am
by gunnarthefeisty
If anyone, by some chance, has a third. I could use one as well.
Re: FOUND: 7" VICTOR TURNTABLE PLATTER
Posted: Wed Mar 29, 2023 11:40 am
by Kevin Clark
Offered up three that I had available. Have one left. In the photos it is the one at the top. This turn table came off a Victor C. With no felt, rusty no nickel plating left was sent to the plater with instructions to only polish the rim and bead blast everything else. This was not followed as they tried to polish the back side and for unknown reasons decided to grind on the boss. Spindle hole is 5/16 and the slot width is for a 3/32 drive pin. Works as intended. Price is 60.00 plus shipping