Page 1 of 1
Wanted: Generic gold plated tonearm with reproducer and back bracket
Posted: Fri Sep 08, 2023 10:09 pm
by schweg
I recently bought an uncommon offbrand machine- the tonearm was replaced with a Brunswick Ultona that was too long. I'd like one that is 9" from the center of the back bracket to the needle chuck. The base of the bracket needs to be 1-¾ inches across. Please PM with what you have and cost. Send pictures if possible. Thanks- Steve
Re: Wanted: Generic gold plated tonearm with reproducer and back bracket
Posted: Fri Sep 08, 2023 10:51 pm
by schweg
Clarification- the opening in the back bracket is 1-¾. Not the flange which hooks to the motor board
Re: Wanted: Generic gold plated tonearm with reproducer and back bracket
Posted: Sat Sep 09, 2023 1:38 am
by Inigo
Have you checked the items for sale? Just this week someone was selling herein a lot of different tonearms....