The Talking Machine Forum — For All Antique Phonographs & Recordings

I have a Nice pot metal Reproducer i Picked up not to long ago and all thats wronge with it, id the 2 little pieces that attatch to the needle bar came un soldered. The spider parts are all fine i just need to re solder the tips at the end of the needle bar.
Any thoughts or ways to do it would be greatfull.
I have a small soldering gun and the tip is small enoughto go inside one of the tear drop holes on the face so there is no need to take it all aprt.
Any methods or tricks anyone knows?
Im sure some of you have done this in the past

I'm not sure if you even relize this but, you already asked this question and it has been answered. I think it is now on page three. I hope that helps.

? i did ask, but i have it set up to send me a email letting me know i had a respose but for some reason it didnt work i will look there, thanks