Page 1 of 1
Photos of Thorens Excelda Turntable Nut Needed
Posted: Fri Jan 17, 2025 9:31 am
by Dave D
Can any provide me with a few close up photos of the turntable hold down nut used on the Thorens Excelda? Mine is missing and I want to make one. Measurements, like diameter and height would be great too!
Thanks!
Dave D
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Fri Jan 17, 2025 11:09 am
by Roaring20s
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Fri Jan 17, 2025 11:32 am
by Dave D
Thank you, James! I should be able to make something like that. I did not realized it was engraved on the top, but anything is better than a hex nut.
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sat Jan 18, 2025 11:21 am
by Dave D
Close enough for me. A little more polishing and then plating and I will be good to go. Thanks again for the photos.
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sat Jan 18, 2025 11:43 am
by jamiegramo
You’ve done an excellent job! I had one of these and I don’t recall it saying ‘MADE IN SWITZERLAND’ on the nut, so maybe some didn’t.
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sat Jan 18, 2025 12:36 pm
by Dave D
Thank you for your kind comments.
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sat Jan 18, 2025 9:43 pm
by Roaring20s
That's a fine job!
James.
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sun Jan 19, 2025 12:04 pm
by Dave D
Thank you! I know it is not exact, but it works and looks better than a hex nut.
Dave D
Re: Photos of Thorens Excelda Turntable Nut Needed
Posted: Sun Jan 19, 2025 6:24 pm
by Phono-Phan
Great job!!!!!