The Talking Machine Forum — For All Antique Phonographs & Recordings

Looking for an extension arm that nest correctly into a Victor E, 10 ⅜ support arm ( mounting surface to center of pivot pin hole). Bolt goes thru the pivot pin hole to mount the extension arm to the support arm allowing the use of a 27 inch horn. The extension arm for the Victor M/ MS is the correct length but nest into a 9.5 inch long support arm. The E 10 ⅜ support arm has a slightly different curve than the 9.5 used on the Victor M /MS. Figure Victor made two different shaped extension arm castings. Possible Victor made one long arm for the use of a 27 inch horn on a Victor E? Extension arm for a Victor M /MS would work, just does not fit the 10 ⅜ arm curve very well.