Page 1 of 1
O Reproducer 2/4 switch replacement
Posted: Thu Oct 23, 2025 9:17 pm
by danohallaron
Does anyone know how to remove and replace the 2/4 switch on a Model O reproducer? It looks like there is a pin holding it in that presses out. But I'd really like to know how to do this.
Re: O Reproducer 2/4 switch replacement
Posted: Thu Nov 06, 2025 7:26 pm
by danohallaron
Since these threads, at least in theory, remain available with a search... Wyatt advises that originally the 2/4 shaft was pinned near the end. It would appear that silver solder has been a common repair for some time. I ended up sending him the current O, which was snapped at the end of the shaft step down, and he skilfully reworked the end of the ORIGINAL 2/4 and made it work flawlessly and only slightly shorter than originally.
Thread closed.