Victor Exhibition tap
Posted: Thu Dec 18, 2025 12:02 am
I was wondering what tap is used to chase the threads on a Victor Exhibition Reproducer thum screw? Thanks for all the help.
I just checked mine, and its a 1-56.
Shawn
The Talking Machine Forum — For All Antique Phonographs & Recordings
https://forum.talkingmachine.info/
Victor Exhibition tap
Page 1 of 1
Re: Victor Exhibition tap
Posted: Thu Dec 18, 2025 9:55 am
Re: Victor Exhibition tap
Posted: Thu Dec 18, 2025 12:41 pm
Thank you for all the help Shawn
Re: Victor Exhibition tap
Posted: Thu Dec 18, 2025 1:25 pm
Shawn to the rescue!
Another good reason to have a caliper and thread pitch gauge!
Mark
Another good reason to have a caliper and thread pitch gauge!
Mark
Re: Victor Exhibition tap
Posted: Thu Dec 18, 2025 2:54 pm
Funny part is that I was a machinist many years ago and I've been trying to find some of my old tools to work with. I finally found a hobby that I can combine my old jod with. If I had know about this hobby I would have kept my tools in storage. But thanks for the information.