Page 1 of 1
WANTED : Victor D motor (Or an MS motor)
Posted: Fri Dec 19, 2025 6:13 pm
by Victor guy1
Needed for my victor D, I know how hard these motors are to come across, I've been looking for what seems like ages.
Thank you everyone
Josh
Re: WANTED : Victor D motor (Or an MS motor)
Posted: Mon Jan 26, 2026 12:36 pm
by JerryVan
Victor guy1 wrote: Fri Dec 19, 2025 6:13 pm
Needed for my victor D, I know how hard these motors are to come across, I've been looking for what seems like ages.
Thank you everyone
Josh
I sent you a PM about a motor...
Re: WANTED : Victor D motor (Or an MS motor)
Posted: Mon Jan 26, 2026 1:08 pm
by Phono-Phan
There is one on Ebay.
Re: WANTED : Victor D motor (Or an MS motor)
Posted: Mon Jan 26, 2026 2:10 pm
by chrisg
One on ebay may need repair
Re: WANTED : Victor D motor (Or an MS motor)
Posted: Mon Jan 26, 2026 10:17 pm
by Ripduf1
I measured the speed control arm on my Fancy D vs my MS and the C to C from the speed control to the governor spindle is 6" and 5" respectively. Just a data point if you thought they would be "plug and play".
Re: WANTED : Victor D motor (Or an MS motor)
Posted: Tue Jan 27, 2026 10:15 am
by JerryVan
Ripduf1 wrote: Mon Jan 26, 2026 10:17 pm
I measured the speed control arm on my Fancy D vs my MS and the C to C from the speed control to the governor spindle is 6" and 5" respectively. Just a data point if you thought they would be "plug and play".
That makes sense. So, a simple extension would need to be added to the MS governor control arm, apparently.