Page 1 of 1

Modified Diamond disc reproducer to be come electric pick up

Posted: Mon Jun 06, 2011 1:18 am
by James
Twenty years ago I bought a Diamond disc reproducer that was modified to be plug to an amplifier. The Reproducer was cut off before the diaphragm shell. The top of the diaphragm shell was cut off as well. A piece of metal was welded just below the cut of the reproducer arm. A round small metal radio speaker(?) :? :? with a centre opening underneth was welded to the rod. The cut opening of the reproducer shell was welded to the centre opening below of the small metal radio speaker(?) :? , giving connection between the reproducer diaphragm and the small metal radio speaker(?) :?. The repruducer weight that is going side by side and holding the T-Bar with the stylus was not altered. An audio out-put coming from the round metal speaker(?) :? was pluged at the audio in-put of the amplifier, I branched it so it goes to the left and right, so there will be sound on both speakers.

I am not an engineer, if someone can explain it more logically, I would appreciate.

James

Re: Modified Diamond disc reproducer to be come electric pick up

Posted: Mon Jun 06, 2011 11:08 pm
by SonnyPhono
I'm intrigued. Are you able to post photos of the setup. I would be very interested to see how this was done.

Re: Modified Diamond disc reproducer to be come electric pick up

Posted: Tue Jun 07, 2011 11:11 am
by James
Here are the photos of the modified Diamond Disc Reproducer to an electric pick up. I forgot that there is a ground at the out put audio line.

Re: Modified Diamond disc reproducer to be come electric pick up

Posted: Tue Jun 07, 2011 1:32 pm
by estott
That looks very much as if it was modified from one of those electric pick ups, the kind which were intended to be fitted on an acoustic machine to play through a radio speaker.