Page 1 of 1
Zonophone travelling arm
Posted: Mon Aug 08, 2011 4:44 am
by Calle
I'm looking for a Zonophone travelling arm; original or reproduction...
Someone an idea where to get it ?
Re: Zonophone travelling arm
Posted: Mon Aug 08, 2011 5:12 am
by gramophoneshane
Have you checked under your bed?
Perhaps you could advertise for one in the Yankee Trader section?
Re: Zonophone travelling arm
Posted: Mon Aug 08, 2011 10:54 am
by SonnyPhono
gramophoneshane wrote:Have you checked under your bed?
???
Re: Zonophone travelling arm
Posted: Mon Aug 08, 2011 10:58 am
by gramophoneshane
SonnyPhono wrote:gramophoneshane wrote:Have you checked under your bed?
???
Well, he's "looking for" a travelling arm, so I assumed he's lost/misplaced it. And I'm sure Calle is aware of the various parts dealers/suppliers that get recommended here all the time...unless of course, this is really a wanted to buy ad, in which case it should not be in this section of the board.
Re: Zonophone travelling arm
Posted: Mon Aug 08, 2011 3:57 pm
by Calle
Well, he's "looking for" a travelling arm, so I assumed he's lost/misplaced it.

No... you're right: I haven't lost/misplaced it... As I do have a Zonophone without several parts, it's still needed to complete.
And I'm sure Calle is aware of the various parts dealers/suppliers that get recommended here all the time...
Yes... and I'm aware that these parts are rare: I haven't found yet a dealer/supplier who's offering it (maybe you know ?

)
unless of course, this is really a wanted to buy ad, in which case it should not be in this section of the board.
You're right, that's maybe a better place to ask...
Re: Zonophone travelling arm
Posted: Tue Aug 09, 2011 3:48 am
by Valecnik
Re: Zonophone travelling arm
Posted: Tue Aug 09, 2011 5:42 am
by Calle
Hello

!
Thanks !
Yes, I've seen it already... but it isn't the right part...
It's the small concave metal arm, not the "rod".
Re: Zonophone travelling arm
Posted: Tue Aug 09, 2011 6:24 am
by Valecnik
Calle wrote:Hello

!
Thanks !
Yes, I've seen it already... but it isn't the right part...
It's the small concave metal arm, not the "rod".
Hello, you might ask the same guy if you have not already. He makes/stocks a lot of that stuff.
