The Talking Machine Forum — For All Antique Phonographs & Recordings

I have my first reproduction logo for sale.This was molded off an original cast iron logo from one of the enterance gates to building 17 of the Victor Talking Machine Co.It shows every detail of the original but weighs a fraction of the original these were 18" in diameter.It is painted gold as that was the first color it was painted when installed at the factory.I have put a hanger on the back to hang above your favorite victor.It goes for $95.00 postage paid.

What material did you make it from?

Clay

This is cast from 40ozs of a 2 part urethane.So it is light enough to hang on the wall unlike the original cast iron.