Victrola VV-XI Table Model - Just Got It

miker2001 · Post by **miker2001** » Wed Jul 09, 2014 2:25 pm

Good going, Cliff. I see you posted it one day and the VERY NEXT day it was repaired! Not bad!!! Congrats on the find and the quick repair.

FloridaClay · Post by **FloridaClay** » Wed Jul 09, 2014 4:13 pm

I had forgotten about the difference on models with the bullet brake. That makes sense. Gold being somewhat soft that type of brake would likely quickly wear it off.

Clay

CDBPDX · Post by **CDBPDX** » Thu Jul 10, 2014 2:17 am

miker2001 wrote:Good going, Cliff. I see you posted it one day and the VERY NEXT day it was repaired! Not bad!!! Congrats on the find and the quick repair.

I was anxious to get it up and running. Didn't know how far I was going to get putting the motor together, wasn't sure if all the parts were there, but they were!

I flattened out the turntable so no more wobble. View a new video on YouTube here:

http://youtu.be/7rAFZ5YLKu4

Cliff

CDBPDX · Post by **CDBPDX** » Thu Jul 10, 2014 6:41 pm

Looks like it might clean up OK.

Scott · Post by **Scott** » Fri Jul 11, 2014 10:43 am

Looking great! Can't wait to see the finished product.

Scott

atopolosky · Post by **atopolosky** » Fri Jul 11, 2014 10:56 am

Can you post a pic of the insides of the record cabinet? I am looking to rebuild one. Thanks - Al

Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It

Re: Victrola VV-XI Table Model - Just Got It