Edison duncan stop reproducer

Discussions on Talking Machines & Accessories
User avatar
Tpapp54321
Victor II
Posts: 284
Joined: Tue Jun 25, 2013 6:38 pm

Re: Edison duncan stop reproducer

Post by Tpapp54321 »

Back again,
Yesterday I contacted George Vollema to see if he had the little metal piece that plugs into the reproducer, he didn't. So does anyone have any ideas on what I could use as the pin for the duncan stop till I track down an original? Many thanks.
-Tom

martinola
Victor III
Posts: 961
Joined: Wed Feb 11, 2009 1:30 pm

Re: Edison duncan stop reproducer

Post by martinola »

Edisone wrote: Prolly rusted solidly together! Yes, it should unscrew but it's been 30 years (gack) since I took mine apart the first time & I don't remember how. It was a struggle, I do remember that much. I may have bent a screwdriver to fit in that space, then held the block in a bench vise so I could use both hands on the screwdriver.
I'm not sure if this would help, but I was able to modify an offset screwdriver with a bench grinder. This particular screwdriver design was beefy enough to give some needed torque. It's a Husky pro 544-238 with the small phillips blade (and part of the handle itself) ground down for clearance. Here's a link to it on Home Depot's site:

http://www.homedepot.com/p/Husky-1-2-in ... /100038024

Here are photos of my modification.
offset_scr_wide.jpg
offset_scr_wide.jpg (275.19 KiB) Viewed 944 times
offset_scr_ground_off_end.jpg
offset_scr_ground_off_end.jpg (297.34 KiB) Viewed 944 times
It was still hard to get that screw to loosen and I still had to soak it in PB Blaster for a few days, but this screw driver did the trick.

Regards,
Martin

martinola
Victor III
Posts: 961
Joined: Wed Feb 11, 2009 1:30 pm

Re: Edison duncan stop reproducer

Post by martinola »

Tpapp54321 wrote:Back again,
Yesterday I contacted George Vollema to see if he had the little metal piece that plugs into the reproducer, he didn't. So does anyone have any ideas on what I could use as the pin for the duncan stop till I track down an original? Many thanks.
-Tom
Tom,

You might try searching some antique radio or telephone parts dealers for that connector. I'm pretty sure I've seen some in the past.

Regards,
Martin

Post Reply