Credenza in Harrisburg PA July 13th

[rizbone]

I know some of you were looking for a Credenza around here.

http://www.auctionzip.com/cgi-bin/aucti ... category=0

[De Soto Frank]

Shame about that broken / missing spandrel from the grille...

I noticed the lack of "record-rest strips" on the deck, and assumed this was an "early" 4-door, but the s/n is in the 25,000 block ?

[OrthoSean]

As far as I know, machines designated as "Credenza" never had the record racks in the playing compartment area. Every 8-30 I've seen and owned has had them though.

George V has grill parts for Credenzas, so replacing that spindle should be easy. I had one with a broken spindle like that years back and bought one from George. I blended the finish and gave it some toned lacquer, fitted it in (there are small dowels that hold them in) and that was that. I had a tough time later remembering which one I had replaced.

I wouldn't let that be a deterrent here. This example has a nice cabinet otherwise and could possibly even have a brass reproducer.

Sean

[De Soto Frank]

At least this one has intact grille cloth...


My two-door has intact grille frame but two huge gashes in the fabric...


I THINK my two-door might be in the 3000 s/n block... plate was missing, but I found a four-digit number stamped into the inside of the back-panel, in the 3600 range... I'm hoping this might be a serial # ?


Hopefully this beast in H-burg will find a good home !



Frank

[edisonplayer]

My Credenza has no "record rest strips"and is a 1926 model.I believe it is also an early 2 door The paper has a December,1925 date.I got it from Jerry Donnell.edisonplayer

[gemering]

In what year and at what serial # (approximately) did the designation change from "Credenza" to 8-30 with off-set turntable and record rack?
Gene

[rizbone]

If this is missing the record rests I probably have a set. If they are missing, and one of you wins it and needs them drop me a message. I think the ones I've seen with the rests have the turntable offset to the right.

[OrthoSean]

The ones with a record rack would have to have the offset turntable. A record will not fit on either side of the turntable on one where it is centered. I've never seen a "Credenza" with the rack, as I said. I think the VDB gives a pretty close timeline on all of this, but I'm not home to check.

Sean

[fran604g]

From the Victor-Victrola Page http://www.victor-victrola.com/8-1.htm

"Record support added at S/N 33800. 8-30 name change implemented around S/N 45000"

[Torjazzer]

As far as I know, machines designated as "Credenza" never had the record racks in the playing compartment area. Every 8-30 I've seen and owned has had them though.

Sean

Mine has the record racks and the I.D. tag reads "Credenza", so there were a number of transitions. I have seen machines with the off-set platter and no rails; machines that were not meant to have them, obviously, as there were no drill holes where the screws might have been.