WANTED Spindle For Columbia

[Phonofreak]

Before I contact the usual dealers, I'll check here first. I am restoring a front mount Columbia and I need the spindle for it. It has the brass cone fitting. These spindles were used for the front mount machines and rear mount machines. It's the same spindle on all the horn machines.
Harvey Kravitz

[Phonofreak]

This spindle was also used on the early Grafonola machines that used a female crank. A junk motor will also be fine.
Harvey Kravitz

[Phonofreak]

It turns out that I need the spindle gear, too. It doesn't matter if it has the fiber gear or not.
Harvey Kravitz