Wanted: Original Victor Flat Crank-Found

[mattrx]

I have an early Vic I that is in need of an original horn elbow. I have a reproduction one, but would like to upgrade to an original. I also would like to find an original slotted flat crank for this same machine. Any help is appreciated.
Thanks,
Matt

Update:

I have found the elbow, now I just need the crank. The crank I need has the following dimensions: Flat side is approximately 3.25 inches long and the slotted end is about 2.25 inches in overall length.

Thanks

[alang]

I think I just saw both of the parts you're looking for on eBay. Pricey though...

Andreas

[mattrx]

The elbow just sold on eBay. I did not with the bidding It went north of $250. Since I have an elbow, just not an original, I did not bid quite that high. As for the crank, I had not seen one until today. At $150 (listed by neelam), it is a bit pricey for one with a split at the slot, but thanks. I've been looking off and on for 6-8 months now on eBay with little to no luck.

Matt

[mattrx]

*bump*

I am still looking for the correct crank if anyone has one for sale. Thanks to drboruff I now have the elbow and it looks perfect!

The crank I need has the following dimensions: Flat side is approximately 3.25 inches long and the slotted end is about 2.25 inches in overall length.


Matt