WANTED: Crank for an Edison BC-34-FOUND

[Victrolaboy]

Hello everyone I'm new to this forum. My name is Nick I'm a 13 year old phonograph collector who has been collecting since I got my first phonograph at age 8. I rebuild motors and yes I install mainsprings, I also restore phonographs and resell them. I run a small business at the flea market here in Nashville, Tennessee and it's lots of fun. I own 10 phonographs but my collection is in the process of going from quantity to quality so only half of them are desirable. So anyway I need a crank for an Edison BC-34. If anybody has a spare crank they could sell me then send me an Email.

[EdiBrunsVic]

Check the Links Section of this forum. There are several good parts sources there. Ron Sitko might have the part you need.

[Victrolaboy]

Ok I will check with Ron. I've bought several mainsprings from him and he is always very helpful and friendly to work with.
Thanks!

[billbossus]

I have an unknown manufacturers crank that is approximately 14" in length. If you know the dimensions or if someone could post a picture of one I could possibly check.

[Lucius1958]

Measurements for the BC-34 crank:

Inner end to first bend - 14" (approx.)

Bend to bend - 5" (approx.)

To end of knob - 3" (approx.)

Bill

[billbossus]

It seems to match up pretty much. Nick PM your name and address and I'll send it to you free. Thanks for the measurements Bill.