WANTED: Tone arm and reproducer for Stewart Phonograph

[mattrx]

I know this is a long shot, but hoping someone here has the tone arm and reproducer for this phonograph. I recently purchased a Stewart Phonograph as a spur of the moment purchase from a seller on eBay. The Stewart Phono is missing the tone arm and reproducer, but otherwise is complete and working. If anyone has the part(s) I need, I would appreciate it, but again, I know it is a long shot, but I though I would try.
Matt

[Curt A]

I got a part for my Stewart from George Vollema last year, so you might try him...

[Retrograde]

FYI... The Stewart has two sizes of tone arms (one big, one small). The small size is 1 inch diameter at the mounting bracket. It's a little hard to tell from the photo, but the stock picture is the smaller of the two. The big one is the most common.

Yours is missing the bottom board.

[mattrx]

Thanks for the advice and information. I'll contact George. The opening for the tone arm on this machine is about 1.25 inches. Hopefully I will eventually find one.
Thanks guys.